Discussion of Avionics and Flight Instruments. Such as: EFIS, EIS, GPS, COM, NAV, Antennas, Audio Panels, Steam Gauges
by JFYrineo » Sat May 04, 2024 5:50 pm
I’ve installed both my V6 radio and iEFIS. Wired and powered up. I enabled my V6 in the iEFIS setup menu as well as set the V6 in the Port #1. I see my COM1 on my iEFIS panel but it is “X’d” out and does not reflect the act/stby on the V6. Am I missing some other setup to make the radio freq. active on the iEFIS. I’ve verified my RS232 TX/RX wiring connections between the V6 and iEFIS.
- Attachments
-
![IMG_2379.jpeg (2.17 MiB) Viewed 412 times IMG_2379.jpeg](./download/file.php?id=5358&t=1)
-
![IMG_2378.jpeg (2.75 MiB) Viewed 412 times IMG_2378.jpeg](./download/file.php?id=5357&t=1)
-
JFYrineo
-
- Posts: 15
- Joined: Sun Feb 13, 2022 7:33 pm
by bvolcko38 » Mon May 06, 2024 8:40 am
Your setup in the menu looks right. I'm thinking its a wire problem.
Bill Volcko XNS0068
Xenos A N68WV 99% flush rivets
Aerovee and Prince P-Tip
MGL Discovery Lite w/ Sandia STX 165R
V6
First hole 4/1/16
First flight 8/24/18
Phase I complete...finally!!!
Also flying a Challenger II since 1999
-
![User avatar](./download/file.php?avatar=1380_1649164383.jpg)
bvolcko38
-
- Posts: 264
- Joined: Fri Feb 19, 2016 7:40 am
Return to Avionics and Instruments
Who is online
Users browsing this forum: No registered users and 4 guests