Re: Tool loan program
Posted: Mon May 04, 2020 7:42 pmAnyone have a B&S #1 Taper Reamer available to borrow?
There is one making its rounds.
Who has it now?
And when do you need it?
SonexBuilders.net
A Forum for Sonex Aircraft Builders and Enthusiasts
http://www.sonexbuilders.net/
Tool loan program
Page 3 of 4
Posted: Mon May 04, 2020 7:42 pmRe: Tool loan program
Posted: Mon May 04, 2020 9:11 pmRe: Tool loan program
Posted: Mon May 04, 2020 11:28 pmI just mailed it to Bill Volcko today; he should get it on Friday!
Re: Tool loan program
Posted: Tue May 05, 2020 10:38 pmBill is planning on sending it to me when he is done with it. Xenos59 send me a PM or TXT with your address, and I'll pass it to you when I'm done. I should be pretty quick with it.
Gregg Short
330-four six five, 75 thirtyone.
Sonex 715
Burbank, OH
Gregg Short
330-four six five, 75 thirtyone.
Sonex 715
Burbank, OH
Re: Tool loan program
Posted: Mon Jun 15, 2020 2:50 pmDCASonex wrote:Those oops fitting tools are out there somewhere. There was a chain of folks wanting to use them and they were to be passed on down. I have lost track of them I hope the person that currently has them or the person before that, reads this and can provide info on their whereabouts.
Dave,
Did you ever find the location for the oops fitting tools? I could sure use them now. I have mine drilled out and the two lower 1/8" fittings are almost impossible to mill down to a flat finish on the inside!
Ken
Re: Tool loan program
Posted: Tue Jun 16, 2020 8:51 amThey are back in my shop, just send address you want them shipped to. Assuming you are in the US, I use Priority mail.
David A.
David A.
Re: Tool loan program
Posted: Tue Jun 16, 2020 12:06 pmDCASonex wrote:They are back in my shop, just send address you want them shipped to. Assuming you are in the US, I use Priority mail.
PM sent with the address. I am in the US.
Thanks!
Ken
Re: Tool loan program
Posted: Tue Jun 23, 2020 8:15 amGregg,
I could use the taper reamer. Did you send it on to Xenos59? Thanks.
Joe
Waiex 181
SE Mich
I could use the taper reamer. Did you send it on to Xenos59? Thanks.
Joe
Waiex 181
SE Mich
Re: Tool loan program
Posted: Sun Sep 13, 2020 11:57 amLooking for the oops fitting tools. Please advise if you have them & when they may be available. Thanks!
Joe
Waiex 181
SE Mich
Joe
Waiex 181
SE Mich
Re: Tool loan program
Posted: Mon Nov 23, 2020 10:29 amAs someone who has personally benefited from this program, I'd like to add my Delphi Weatherpack connector tools to the list. PM me if you need them, I can ship after I'm completely done with my project.
- Not too expensive, but why buy if you don't have to?