Page 2 of 2
Re: My Rotax Mount for a Onex
Posted:
Mon Feb 21, 2022 5:23 pmby lgoodenow
I have a Onex trigear with the Aerovee. Considering a Rotax 912 but concerned about mounting options, CG adjustments, placement of oil/water cooling, exhaust options, propeller adjustment if needed…etc. Some of you have done this and are flying. Would greatly appreciate feedback on build considerations and flying characteristics.
Re: My Rotax Mount for a Onex
Posted:
Thu Feb 24, 2022 8:41 pmby Skippydiesel
gcm52 - my compliments. You have managed to achieve a very clean looking engine mount, with lots of space between firewall & engine (despite the nose wheel )
Re: My Rotax Mount for a Onex
Posted:
Fri Feb 25, 2022 10:20 amby aschlem77
Where did you get the cups for the rubber isolators? I'm getting ready to make a 912 ring mount for my sonex
Re: My Rotax Mount for a Onex
Posted:
Sat Feb 26, 2022 9:33 amby gcm52
I fabricated the cups based on a drawing sent to me by I think by Lord, who makes the rubber isolators, or maybe the drawing was in the Rotax install manual, I am not sure as it has been a while.