Look what I found!

Discussion of the Aerovee kit engine.

Re: Look what I found!

Postby rizzz » Sat Oct 03, 2015 4:08 am

Sonerai13 wrote:
rizzz wrote:60 pound inches on these little nuts? Are you sure about that number?
I think mine are 20-25, similar to a AN3's.


AeroVee Assembly Manual, table of torque values (Page 62 in the current revision). "Oil Pan Cover Nuts - 5 pound feet or 60 pound inches". Check it out!


Hmmm, so it does, and my GP manual says the same must be right then, thanks Joe.
I just went off how I saw John Monnett do them in the original AeroVee video, he just used a very small wrench and said "not to overtorque these nuts".
Anyway, I'll do them up to 60 when I change the oil (which is in the coming week anyway).
Michael
Sonex #145 from scratch (mostly)
Taildragger, 2.4L VW engine, AeroInjector, Prince 54x48 P-Tip
VH-MND, CofA issued 2nd of November 2015
First flight 7th of November 2015
Phase I Completed, 11th of February 2016
http://www.mykitlog.com/rizzz/
rizzz
 
Posts: 869
Joined: Tue Jun 21, 2011 2:07 am
Location: Wollongong, NSW, Australia

Previous

Return to Aerovee

Who is online

Users browsing this forum: No registered users and 16 guests