All-
Got a question about these 2 brackets. I made a slight mistake and drilled the holes too close to the angle. Between that and a 1/16-1/8 measurement on the fuse bottom leaves no room to put in cross members. Plus I up drilled so will need to get some oops rivets :oops:
1. Can I salvage the current bracket and re-dril next to the current holes? I'm thinking no.
If not...
2. Can I use a 3/16 x 2 1/2 angle (got plenty) instead of the 1/8 angle for these 2 brackets? I'm concerned that the extra 1/16 may somehow cause a problem.
3. Have to order more 2 1/2 angle?
You learn that some pieces allow for "close is good enough" and some just dont! This is not one where there is room for error.
Thanks
Alex
SNX-794. Formerly SNX-1542